Sonntag, 27. Februar 2011

Pot Lifter

For this project I basically copied the MSR Lite Lifter design from a picture, and freehanded it onto the aluminum sheet. It's made out of 1.5 mm aluminum. The padding on the handle is 1 mm thick sticky-backed neoprene. Total weight 23 grams. That's a whopping 20 grams lighter than my Trangia handle, so I almost cut the weight in half! It's not quite as bomb-proof as the Trangia, but it does just fine lifting my Trangia 1.5 liter pot full of water. Here's a few pics:


Keine Kommentare:

Kommentar veröffentlichen